Atech-flash-technology XM-35U Manuel d'utilisateur télécharger pdf (Page 7)

Therefore, we shall have:

Red wire goes to pin 1

White wire goes to pin 2

Green wire goes to pin 3

Black wire goes to pin 4

Red wire goes to pin 6

or White wire goes to pin 7

Green wire goes to pin 8

Black wire goes to pin 9

Comparing the default wire setting on the Internal USB cable, no wire reassignment is

necessary. We can plug in the black pin connector of Internal USB cable to the USB

header directly, with red wire goes to pin 1 or 6.

Please note that your motherboard USB header pin assignment could be different from

the example above. If you need to reassign wires on Internal USB cable, please

follow the procedure below:

(1) Determine which wires you need to remove from the

black pin connectors first by referring to your motherboard

USB header pin layout.

(2) Using a needle or push pin to flip up the tiny plastic tab

and pull the wire out from the connector. Please take caution

on this step as excessive force on flipping the tab may cause

the tab to break.

(3) Repeat above step for each wire that requires changing.

(4) Insert the wire pin back into the correct slot and press the

tiny plastic tab down will hold the wire in its position.

1 2 3 4 5 6 7 8 9 10

Pas de commentaire

Atech-flash-technology XM-35U Manuel d'utilisateur Page 7