Atech-flash-technology XM-35U Manuel d'utilisateur télécharger pdf (Page 6)

Connecting Card Reader

1. open computer case cover. Please refer to your computer manual if necessary.

2. Insert XM-35U into empty 3.5" drive bay.

3. Apply screws on each side of unit to secure to chassis,

4. Connect Internal USB cables to unit then to Motherboard USB header pin

5. For external use, connect the External USB cable to back of unit.

/ Left USB is for Reader

Right USB is for front USB port

Mothertxtard connection

Depending on the pin layout on your motherboard USB header, it may be necessary to

rearrange the color wires of Internal USB cable to match the USB pin assignment.

Please refer to your motherboard manual for USB header pin assignment information.

Internal USB cable consists of Red. White. Green and Black wires. Each color wire shall

be connected to a specific pin on the USB header.

Red wire = Power (VCC)

White wire = P- (Data-)

Green wire = P+ (Data+)

Black wire = Ground (GND)

Pm 1 s u&B Power

Pm 2 » US6P2-

Pm 3 • US8P2*

Pm4«0ND

Pm5s^н:

Pm 6 • US6 Power

Pln7*US6P3-

Pm 8 s U$BP3*^

Pin 9 s GND

Pm 10 9 NC (No pin)

1 2 3 4 5 6 7 8 9 10

Pas de commentaire

Atech-flash-technology XM-35U Manuel d'utilisateur Page 6